If you decide to cut back the lead wires, it is suggested you do so in the following manner: Depending on the length of downrod you use, you may need to cut the lead wires back to simplify the wiring. Tighten set screws in yoke and then tighten nuts on the set screws.Ĥ. Slip downrod (A) into yoke, align holes and re-install pin (M) and clip (N). Thread wires from motor housing (D) up through downrod (A).ģ. Remove pin (M) and clip (N) from yoke at top of motor housing (D) and partially loosen preassembled set screws and nuts.Ģ. For CLOSEMOUNT-STYLE FAN MOUNTING, skip to page 9.ġ. įor DOWNROD-STYLE FAN MOUNTING, proceed to step 1 below. Remove motor screws (I) and lock washers (K) from underside of motor housing (D). IMPORTANT: If using the angle mount, make sure open end of mounting bracket (C) is installed facing the higher point of the ceiling, and ensure the ceiling angle is not steeper than 19°.ĥ. *NOTE: It is very important you use the proper hardware when installing the mounting bracket (C) as this will support the fan. Secure mounting bracket (C) to outlet box (not included) using screws, spring washers and flat washers provided with the outlet box. A longer downrod is sometimes necessary to ensure proper blade clearance.ģ.Check to make sure blades (F) are at least 30 in. Angle-style mounting is best suited for angled or vaulted ceilings. For taller ceilings you may want to use a longer downrod (not included). *Helpful Hint: Downrod-style mounting is best suited for ceilings 8 ft. IMPORTANT: If using the angle mount, check to make sure the ceiling angle is not steeper than 19°. Downrod-style mount (standard or angled ceiling)ī. Helpful Tools (not included): AC Tester Light, Tape Measure, Do-It-Yourself Wiring Handbook and Wire Cutters INITIAL INSTALLATIONġ.Turn off circuit breakers and wall switch to the fan supply line leads.ĭANGER: Failure to disconnect power supply prior to installation may result in serious injury or death.Ī. ![]() Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers If any part is missing or damaged, do not attempt to install, operate or assemble the product. ![]() Compare parts with package contents list and hardware contents list. HARDWARE CONTENTS (shown actual size)īefore beginning assembly of product, make sure all parts are present. IMPORTANT REMINDER: You must use the parts provided with this fan for proper installation and safety.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |